Wallplate Installation - Honeywell PRO TH1000 / TH2000 Series Installation Manual

Installation Guide

Wallplate installation

CAUTION: ELECTRICAL HAZARD
Can cause electrical shock or equipment damage. Disconnect power
before beginning installation.
Loosen the locking screw at the bottom of the thermostat. Note that the screw is
captive and cannot be removed from the wallplate.
Separate the thermostat from the wallplate as per Figure 1.
Position the wallplate against the wall and mark hole positions with a pencil.
NOTE: Levelling is for esthetics only and will not affect the performance of the
thermostat.
Drill holes at the marked positions and insert supplied wall anchors.
Pass the wires through the large opening located at the bottom center of the wallplate
as per Figure 2.
Secure the wallplate to the wall with supplied mounting screws as per Figure 3.
Connect the wires to the terminals.
Figure 1
MERCURY NOTICE
If this product is replacing a control that contains mercury in a sealed tube,
do not place the old control in the trash. Contact your local waste
management authority for instructions regarding recycling and proper
disposal.
Figure 2
2
Figure 3