Normal Sounds - Whirlpool Ad70Uss Manual

3. Pour water through opening into a sink or
tub.
4. Reinstall bucket.
IMPORTANT: If the Empty/Adjust Bucket
light comes on, the dehumidifier will not
operate. Empty or adjust bucket.
Option 2—Connect Drain Hose
If you plan to run your dehumidifier continu-
ously, you may want to attach a garden hose
to the drain hose connector.
1. Use a flat-blade screwdriver to gently pry
out the drain hose connector cover. Discard
the cover.
B
A. Drain hose connector cover
B. Bucket
2. Remove bucket.
A
3. Attach a garden hose to drain hose connec-
tor on the inside of the dehumidifier. Hand
tighten.
4. Place the other end of garden hose into a
floor drain. Check to see that the hose lies
flat and is in the drain.
5. Reinstall bucket.
NOTES:
• To use the bucket without the garden hose,
remove the garden hose. Then reinstall
bucket.
• The bucket must be installed and properly
aligned for the dehumidifier to operate with
or without a garden hose connected.

NORMAL SOUNDS

When your dehumidifier is operating normally,
you may hear sounds such as:
• Compressor sounds, which may be loud.
This is normal.
• Clicking sounds when the dehumidifier or
compressor turns off and on, and when the
Automatic Shutoff Switch is working.
• Air movement from the fan.
2-7
B
A
A. Garden hose
B. Drain hose connector