STEP 1:
(Figure 12)
Assemble the upright tubes to the base assembly.
NOTE: If holes are difficult to align, loosen bolts attaching
base tubes to mounting bracket(s). If hole alignment is
still difficult, loosen bolts attaching mounting bracket to
rear fender. Retighten all bolts when finished.
STEP 2:
(Figure 13)
Assemble the top tubes to the upright tubes. Do not
tighten yet.
STEP 3:
(Figure 13)
Fit the front U-tube onto the top tubes. Fasten the tubes
together. Tighten all loose bolts and nuts.
STEP 4:
(Figure 13)
Fit the three support rods into the holes in the top tubes,
with the rods arching upward. Do not over-bend the rods
when installing.
STEP 5:
(Figure 14)
Place the vinyl canopy on top of the tubing frame, fitting
the front of the vinyl canopy around the front U-tube.
Secure the nylon mesh to the upright tubes using the ties
located on the corners of the mesh.
CAUTION: Make sure tractor seat raises
and lowers freely after attaching Sun
Shade. The tractor's operator presence
safety switch will not operate if seat is
stuck down.
Call 1-866-576-8388 for missing parts or assembly help
DO NOT RETURN TO STORE
CANOPY INSTALLATION
UPRIGHT
TUBES
PLASTIC
KNOB
1/4" x 1-1/2"
HEX BOLT
U-TUBE
1/4" NYLOCK
NUT
1/4" x 1-1/2"
HEX BOLT
5/16" x 2"
CARRIAGE BOLT
5/16" FLAT
WASHER
FIGURE 12
SUPPORT ROD
TOP TUBES
1/4" NYLOCK
NUT
FIGURE 13
FIGURE 14
9
Need help?
Do you have a question about the 486.24227 and is the answer not in the manual?
Questions and answers