Assembly Instructions For Tractors; With Single Suspension Bracket - Craftsman 486.24227 Operator's Manual

ASSEMBLY INSTRUCTIONS FOR TRACTORS WITH
NOTE: Right hand (RH) and left hand (LH) are
determined from the operator's position while seated on
the tractor.
STEP 1:
(Figure 2)
Place the base bracket on a flat surface. Identify the
highest hole on each side of the bracket.
STEP 2:
(Figure 2)
Attach the base bracket as shown to the first and
second holes from the end of the flattened base leg
tube. Make only finger tight.
STEP 3:
(Figure 3)
Attach the other end of the base bracket to the fourth and
fifth holes from the end of a round base leg tube. Make
only finger tight.
STEP 4:
(Figure 4)
Attach the long end of the right support bracket to the
outside of the flattened base leg tube. The bolt head must
be on the inside of the base leg tube. Make only finger
tight.
STEP 5:
)
(Figure 5
Attach the left support bracket to the outside of the left
base leg tube. Make only finger tight.
6
SINGLE MOWER DECK SUSPENSION BRACKET
5/16" NYLOCK NUT
THIS HOLE
IS HIGHER
5/16" x 2"
CARRIAGE BOLT
BASE BRACKET
5/16" x 2"
CARRIAGE BOLT
THIS HOLE
IS HIGHER
5/16" NYLOCK NUT
1/4" x 1"
CARRIAGE
RIGHT
BOLT
SUPPORT
BRACKET
(long end)
5/16" NYLOCK
NUT
5/16" x 2"
HEX BOLT
LEFT
BASE LEG TUBE
SUPPORT
(ROUND END)
BRACKET
Call 1-866-576-8388 for missing parts or assembly help
BASE LEG TUBE
(FLATTENED END)
FIGURE 2
BASE LEG TUBE
(ROUND END)
FIGURE 3
1/4" NYLOCK
NUT
BASE LEG TUBE
(FLATTENED END)
FIGURE 4
FIGURE 5
DO NOT RETURN TO STORE