Download  Print this page

Fitting The Wok Burner; Regulating The Minimum Flow Level Of The Gas Taps - KitchenAid KHPS 9010 Manual

Hide thumbs

Advertisement

Fitting the wok burner

To fit the double crown wok burner:
Insert in the following order:
1. burner ring (A);
2. decorative covering ring (B);
3. external burner cap (C);
4. internal burner cap (D).
Note: make sure that:
1. the locating pin for the burner ring (A) is inserted correctly in the
slot on the burner unit.
2. that the locating pin on the external
burner cap (C) is inserted in the slot
on the burner ring (A).

Regulating the minimum flow level of the gas taps

Regulating the minimum flow level must be done with the tap at the
lowest position (small flame)
There is no need to regulate the primary air in the burners.
To ensure the minimum level is properly regulated, remove the
control knob and adjust the screws found on the tap as follows:
1. tighten to reduce the height of the flame 1 (-)
2. slacken to increase the height of the flame (+);
3. With the burners on, rotate the buttons from the maximum
the minimum position
Once you have finished regulating, close up the seals again using
sealing wax.
.
to check the stability of the flame.
to
13

Advertisement

loading

This manual is also suitable for:

Khpf 9010