AEG 36" 3009VNM-M User Manual page 9

WARNING:
A licenced electrician must connect the armour cable and 3 wires into the electrical
connection box. The white, or Neutral wire is not used, and must be capped using a
marette.
To avoid power borne interference, this appliance must be installed individually on a separate and
distinct final sub-circuit.
Note:
To the electrician – please ensure sufficient supply cable is provided to allow the appliance to be
removed from the cavity should any servicing be necessary. This will also allow easy connection
of the supply.
Voltage supply connection
To connect the electrical supply:
1- Ensure the supply cable and fuse rating are suitable for the appliance (see the electrical
loading).
2- Remove the cover plate by undoing the screw.
3- Fit a suitable entry bush to the conduit entry on the rear left of the appliance (with the rear
toward you) and feed the fixed wiring through.
4- Connect the wiring to the terminal block using the screw connections provided. Ensure
the wires are properly secured to prevent any high resistance electrical connection.
5- Replace the cover plate making certain that the supply wiring is clear of any metal work
and the screws.
6- If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified persons in order to avoid hazard
When connected to a sub circuit, protected by a circuit breaker, it is recommended the circuit
breaker be the same as the total rating of the appliance.
To full disconnect the power supply, it is necessary to have a proper mean in the fixed
wiring in accordance with the wiring rules. It must have full disconnection under
overvoltage category III conditions.
Electrical Loads
Oven
Grill
Oven fan and light
Cearmic cooktop
TOTAL RATING AT
208V
TOTAL RATING AT
240V
2350 W
2800 W
90 W
8600 W
10.30 KW
13.66KW
Oven
Grill
Oven fan and light
Gas cooktop
TOTAL RATING AT
208V
TOTAL RATING AT
240V
2350 W
2800 W
90 W
3.22KW
4.05KW
9