Asus E1816 User Manual page 39

4.7.7 QoS Setup
The system support 2 level priority queues. The queue service rate is based on
the packet-based Weighted Round Robin algorithm. The ratio can be set as
4:1, 8:1, 16:1, or strictly high priority first.
The port-based priority is to decide the packet priority by the receiving ports.
You can select the high priority ports from the switch graphic.
If TOS/DSCP based priority is enabled, it will be assigned to high priority queue
if the field value is:
expected forwarding: 0b101110;
assured forwarding: 0b001010, 0b010010, 0b011010, 0b100010
network control: 0b11x000
If 802.1p based priority is enabled, the packet forward priority is decided by the
CoS value. The high priority packets have the CoS value from 4 to 7.
In some situations, you may want the high priority packets to get forwarded
even the 802.3x flow control stop transmitting packets. In this case, enable
Adapted Flow Control will turn off 802.3x flow control for a short time to let the
high priority packets get forwarded. The 802.3x is re-enable when no high
priority frames are received for 1 to 2 seconds. See figures below.
GigaX Smart Switch Centralized Network Management
Figure 4.24 QoS Setup (GigaX 1024P)
39