Asus E1816 User Manual page 31

Figure 4.18.1 Physical Interface (GigaX 1024I)
Above shows the configuration for each port. Select the ports you want to
configure or reload information from the switch by clicking on the check boxes
in front of the ports, then click on Config to set the configuration for the ports,
or click on Reload to retrieve configuration from the switch, or click on Apply to
apply the new settings to the switch. Some settings you can do to the physical
interface.
1. Enable or disable a port
2. Speed and duplex mode. Select 1000 full-duplex (GigaX 1024P only) on the
Fast Ethernet ports (from 1 to 24) will set the ports to 100 full-duplex mode.
3. Flow control - Back pressure flow control is used in half and full duplex modes to
prevent packet loss.
A software reset will be triggered after the configuration is apply. The purpose
of software reset is to restart link negotiations.
GigaX Smart Switch Centralized Network Management 31