Renault Megane Berline Handbook page 119

LANE DEPARTURE WARNING
1
Activation
Press button 1: the warning light on
the 1 button lights up, accompanied by
the message "Lane deviation warning
on" and a beep.
The function sounds the alarm if:
– the warning light on the 1 button
lights up;
and
– the vehicle speed is greater than ap-
proximately 45 mph (70 km/h);
and
– lines are detected.

Warning light comes on on the
instrument panel to notify the driver.
(2/2)
When a line is crossed and the indica-
tors have not been activated, the func-
tion alerts the driver through warning

light on the instrument panel,
and a beep.
Conditions for non-activation
of alerts
– Indicators activated or having been
activated less than approximately
four seconds prior to departing from
the lane;
– Very fast lane departure;
– Driving continuously on a line;
– On bends, the function allows for
slightly cutting the bend;
– ...
Adjustment
From the vehicle settings customisation
menu (please refer to the information
on the "Vehicle settings customisation
menu" in Section 1), you can:
– adjust the alert audio volume. To
do this, select "lane departure alert:
volume" (five levels);
– adjust the alert sensitivity. To do this,
select "lane departure alert: sensitiv-
ity" (three levels).
Deactivation
Press button 1 on the central rear-view
mirror.
The warning light on button 1 goes out,
accompanied by a message on the in-
strument panel "Lane departure warn-
ing de-activated".
Operating faults
In the event of a malfunction, a mes-
sage "Lane departure warning check" is
displayed on the instrument panel, and
the warning light on button 1 stays off.
Consult an approved dealer.
2.27