Renault Duster Handbook page 139

TYRE INFLATION KIT
8
Once the tyre is inflated correctly:
– stop using the kit;
– close the integrated cap on the bottle
again;
– disconnect adapter 8;
Nothing should be placed
around the driver's feet
as such objects may slide
under the pedals during
sudden braking manoeuvres and
obstruct their use.
(3/3)
– affix driving
label 10 to the dashboard where it
can easily be seen by the driver;
– store the kit;
– after the first inflation procedure the
tyre will still be leaking; it is vital to
drive in order to plug the hole;
– start immediately and drive at be-
10
tween 12 and 36 mph (20 and
60 km/h) to distribute the product
evenly throughout the tyre, stopping
after a distance of 2 miles (3 kilome-
tres) to check the pressure;
Following repair with the kit,
do not travel further than
120 miles (200 km). In addi-
tion, reduce your speed and
under no circumstances exceed
48 mph (80 km/h). The sticker,
which you must affix in a prominent
position on the dashboard, reminds
you of this.
Depending on the country or local
legislation, a tyre repaired with the
tyre pressure kit will need to be re-
placed.
recommendation – if the pressure is greater than 1.3 bar
Note: after using the inflation kit, you
should visit an approved dealer to re-
place the inflation hose and the bottle
of repair product.
Precautions when using the
kit
The kit should not be operated for more
than 15 consecutive minutes.
Always use valve caps which are
identical to the originals and fully
tightened.
but less than the recommended
pressure (refer to the label affixed to
the edge of the driver's door), read-
just it; otherwise, please contact an
authorised dealer: the tyre cannot be
repaired.
Important: a missing or
loose valve cap may com-
promise the tyre seal and
cause a loss of pressure.
5.7