Consumer Defined Control Features; Temperature Display (Fahrenheit Or Celsius); Sitent Control Operation - Kenmore 790.46832 Use & Care Manual

Consumer Defined Control Features
FEATURE OVERVIEW
• Temperature Display
• Silent Control Operation
Setting Temperature Display -- Fahrenheit or Celsius:
The BROIL (_ and CLEAN O pads control the Fahrenheit or Celsius temperature display modes. The oven
control can be programmed to display temperatures in Fahrenheit or Celsius. The oven has been preset at the factory to
display in Fahrenheit.
INSTRUCTIONS PRESS DISPLAY
To change display from Fahrenheit to Celsius or
Celsius to Fahrenheit:
1. To tell if the display is set for Fahrenheit or Celsius press and
hold the (_ pad. "BROIL", "550 °" will appear in the display
(see Fig. 1 ) and continue to HOLD for 7 seconds. A beep will
then sound. If "F" appears, the display is set to show
temperatures in Fahrenheit (Fig. 2). If "C" appears, the display
is set to show temperatures in Celsius (Fig. 3).
Press _ to switch between Fahrenheit or Celsius display
2.
modes. The display wilt show either "F" (Fig. 2) or "C" (Fig. 3).
3. Press _ to accept the change or press _ to reject the _
change.
O for 7seconds
Figure 1
Figure 2
Figure 3
m
z
Z
Setting Silent Control Operation
The STOP TIME _ and CLEAN _ pads control the Silent Control operation feature. The Silent Control operation
feature allows the oven control to be operated without sounds or beeps whenever necessary. If desired the control can be
programmed for silent operation and later returned to operating with all the normal sounds and beeps.
INSTRUCTIONS PRESS DISPLAY
To change control from normal sound operation to
silent control operation:
1. To tell if your range is set for normal or silent operation press
and hold _ for 7 seconds. "DELAY" will appear and flash
in the display (Fig. 4). If ":SP" appears (Fig. 5), the control will
operate with normal sounds and beeps. If ":- -" appears (Fig.6),
the control is in the silent operation mode.
2. Press _ to switch between normal sound operation and
silent operation mode. The display wilt show either ":SP" (Fig. 5)
or ":--" (Fig. 6).
for 7seconds
Q
3. Press _ to accept the change or press _ to reject the
change.
Qo,
17
Figure 4
Figure 5
Figure 6