User Maintenance Instructions; Care And Cleaning; Air Gap - Kenmore 14471 Owner's Manual

;ARE OF SURFACES
'can control panel with lightly dampened
ath. Dry thoroughly.
DO NOT use abrasives or sharp
objects--they could damage the control
panel.
• Clean outside cabinet finish with a good
appliance polish wax. DO NOT use
scouring pads, harsh or gritty cleaners.
• Interior is self-cleaning with normal use. If
it should ever need cleaning, use a mild
cleansing powder. If hard water causes
lime build-up, clean as follows:
Ipour 2 cups white vinegar into empty
dishwasher. DO NOT use detergent.
IOperate machine on NORMAL WASH
cycle.
PROTECTION AGAINST
FREEZING
If dishwasher is left in an unheated place
during the winter:
• Shut Off water and electrical power.
• Remove access panel.
• Disconnect water lines from valve. Drain
into a flat pan,
• Drain collection chamber at rear of unit
below filter by disconnecting hose to
pump.
• Remove plastic pump cover in tub bottom
and use sponge to soak up any
remaining water.
• Reconnect water lines to valve and hoses
to pump.
Pumpcover screws
UARE OF AIR GAP
If an air gap was installed for your built-in
dishwasher, check to make sure it is clean.
Ai r gaps are usually mounted on the
countertop and can be inspected by
removing the cover. The air gap is not part
of your dishwasher and is not covered by
Sears warranty.
Drain air gap
13
PREPARATION FOR MOVING
• Disconnect electrical power.
• Turn off water supply, disconnect water
and drain lines.
• Tape racks in place; close door securely
and tape it shut.
• Wrap with blankets and, if using a hand
truck, li!t dishwasher from side in upright
position only