Table of Contents
Advertisement
Available languages
Available languages
REMOVING CLOGS
The vacuum cleaner creates suction that picks up dirt. Rapidly
moving air carries the dirt to the dust bag through the airflow
passages. The dust bag lets the air pass through, while it traps
the dirt.
For best cleaning results, keep the airflow
passage open. Check the starred areas
occasionally for clogs. Turn off
and unplug from the outlet
before checking.
Motor
Safety
Filter
Exhaust
BAG CHANGING
For best cleaning results, the dust bag should be
changed often.
NOTE: See PARTSAND FEATURESfor Bag
number.
1. Turnoff and unplug the vacuum cleaner.
4. Disengage
cardboard
tab from
red bag mount by
pulling away and
lifting up.
5. Pull bag out of the
red bag mount.
2. Remove hose from
canister.
3. Pull hood release
out
and up, then lift
canister
hood.
Motor.
Safety
6. Check
motor
- Filter
safety
filter
and
clean,
if
Red Bag
necessary.
; Mount
Z The red bag mount will flip forward
after
removing bag. This will prevent the hood from
closing until a new bag is installed.
Note: DO NOT bend or crease the middle of
the cardboard when installing the bag into the
bag mount slots.
8. Rotate red bag mount down and install bag
into slots per illustration, pushing down until the
cardboard
tab locks
into position and the
holes align. Tuck the
bag securely into the
bag cavity so that
none of it is able to be
pinched by the hood.
9. Close and latch
canister hood.
10. Reinstall hose.
11.Plug cord into wail outlet.
CAUTION
NEVER REUSE A DUST BAG. Very fine materi-
als, such as carpet freshener, face powder, fine
dust, plaster, soot, new carpet lint, etc. can cloc
the bag and cause it to burst before it is full
and cause damage to vacuum cleaner motor.
Change bag more often when vacuuming
these materials.
15
Advertisement
Table of Contents
