DUST CUP CLEANING
TO ASSEMBLE
DUST CUP
TO DISASSEMBLE DUST CUP
Remove
dust cup from vacuum
cleaner
(See DUST CUP EMPTYING)
and empty
contents.
1. Rotate
upper
dust
cup to unlock,
then
lift off.
'2. Remove pre-filter
by
pulling downward
as shown.
See PRE-FILTER CLEANING
3. Press the lid
release
button
downward
and
twist lid to remove
from dust cup.
4. Rotate fastener ring
to unlock, and lift off.
5. Remove upper
portion of dust cup
from air guide.
6. Rinse with cold
water only, DO NOT
use detergent
or soap.
Allow parts to dry 24
hours before
putting
back
into vacuum
cleaner.
DO NOT wash in the
dishwasher.
DO NOT install parts
damp.
1. Reinstall
upper
portion of dust cup
onto air guide
so
that the locking
screws pass
through the
holes inthe
upper portion,
;!:_i_ iI!! .....
'2. Using alignment
marks
on the fastener
ring and
dust cup, place fastener
ring onto dust cup and
rotate
to lock in place.
3. Place the dust cup
lid on the upper
portion of the dust cup
using aligniment
slots,
and rotate
until the lid
locks in place.
should
be heard.
I
4. Reinstall
pre-filter
by using the
alignment
ribs on the
pre-fitter
to align with
the ribs on the upper
portion of the dust
cup.
5. Press into place. A
noticeable
"click"
6. Reinstall lower
portion of the dust cup
by aligning ribs on the
upper portion with the
UNLOCK ribs on the
lower portion.
Z Rotate until ribs
from the upper portion of the dust cup
align with the LOCI< ribs.
NOTE:
If lower portion of dust cup does
not fit properly
check
pre-filter
installation
in step 4.
-18-