Step 2-Power Down; Step 3-Set Jumpers; Table 10-1. Perc 3/Qc Jumper Settings - Dell PowerEdge Expandable RAID Controller 3 User Manual

Step 2—Power Down
Turn off the computer and remove the cover. Make sure the computer is
turned off and disconnected from any networks before installing the
controller.
Step 3—Set Jumpers
Make sure the jumper settings on the PERC 3/QC card are correct. Table
10-1 displays the jumpers and connectors.
Ta b l e 1 0 - 1 . P E R C 3 / Q C J u m p e r S e t t i n g s
Connector Description
J1 Channel 1 internal Wide SCSI
J2 Channel 0 termination enable
J3 Channel 1 termination enable
J4 Channel 0 internal Wide SCSI
J5 Channel 2 termination enable
J6 SCSI activity light emitting diode
(LED)
J7 Channel 3 termination enable
J9 Channel 0 TERMPWR enable
J10 Channel 1 TERMPWR enable
J11 Channel 2 TERMPWR enable
J12 Channel 3 TERMPWR enable
J13 Channel 0/1 external Wide SCSI
J14 Serial port connector
J17 Dirty cache LED
J18 Serial EEPROM port
J19 Onboard BIOS enable
J22 Channel 2/3 external Wide SCSI
J23 External battery connector
Type
68-pin connector
3-pin header
3-pin header
68-pin connector
3-pin header
4-pin header
3-pin header
2-pin header
2-pin header
2-pin header
2-pin header
Dual 68-pin connector
9-pin connector
2-pin connector
2-pin header
2-pin header
Dual 68-pin connector
5-pin connector
PE RC 3/ QC Har d war e In s ta l lati on
137