Dell Studio 1535 Service Manual page 13

Hide thumbs Also See for Studio 1535:
Table of Contents

Advertisement

NOTE:
The pin-1 corner of the processor module has a triangle that aligns with the triangle on the pin-1 corner of the ZIF socket.
When the processor module is properly seated, all four corners are aligned at the same height. If one or more corners of the module are higher than the
others, the module is not seated properly.
1 ZIF-socket cam screw 2 ZIF socket
3 pin-1 corner
 
 
NOTICE:
To avoid damage to the processor, hold the screwdriver so that it is perpendicular to the processor when turning the cam screw.
 
3. Tighten the ZIF socket by turning the cam screw clockwise to secure the processor module to the system board.
 
4. Replace the processor thermal-cooling assembly (see
 
5. Replace the base cover (see
Back to Contents Page
 
Replacing the Processor Thermal-Cooling
Replacing the Base
Cover).
Assembly).

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Studio 15361537

Table of Contents