Removing A Pci Express Card - Dell Dimension E520 Service Manual

Removing and Installing Parts: Dell Dimension E520 Service Manual
13. Reconnect the computer and devices to electrical outlets, and then turn them on.
14. If you installed a sound card:
a. Enter system setup (see
b. Connect external audio devices to the sound card's connectors. Do not connect external audio devices to the
microphone, speaker/headphone, or line-in connectors on the back panel.
15. If you installed an add-in network adapter, and want to only use it, then disable the integrated network adapter:
a. Enter system setup (see
b. Connect the network cable to the add-in network adapter's connectors. Do not connect the network cable to the
integrated connector on the back panel.
NOTE: You can use the integrated NIC and add-in NIC adapter at the same time. In this case, set the
Integrated NIC setting to On and install the driver for the add-in adapter.
16. Install any drivers required for the card as described in the card documentation.

Removing a PCI Express Card

1. Follow the procedures in
2. Remove the computer cover (see
3. Gently push the release tab on the card retention door from the inside to pivot the door open. The door is hinged and
will remain in the open position (see
4. If your computer includes a card retention mechanism, to secure the x16 card in place from the top:
a. Pivot the mechanism upward and gently squeeze in on the sides to release the mechanism from the two tab slots
holding it in place.
b. Set the retention mechanism aside.
5. If you are removing the card permanently, install a filler bracket in the empty card-slot opening.
NOTE: Installing filler brackets over empty card-slot openings is necessary to maintain FCC certification of the
computer. The brackets also keep dust and dirt out of your computer.
6. Reseat the card retention mechanism in the tabs and pivot downward to snap it into place.
7. Close the card retention door to snap it into place, securing the cards.
NOTICE: To connect a network cable, first plug the cable into the network device and then plug it into the computer.
8. Replace the computer cover (see
9. Reconnect the computer and devices to electrical outlets, and then turn them on.
10. Remove any drivers required for the card as described in the card documentation.
11. If you removed a sound card:
a. Enter system setup (see
b. Connect external audio devices to the audio connectors on the back panel of the computer.
12. If you removed an add-in network adapter:
file:///T|/htdocs/systems/dimE520/en/SM_EN/parts.htm[10/16/2012 1:05:24 PM]
Setup), select Audio Controller, and then change the setting to Off.
System
System Setup), select Integrated NIC, and then change the setting to Off.
Before You Begin.
Removing the Computer
Installing a PCI Card
Replacing the Computer
System Setup), select Audio Controller, and then change the setting to On.
Cover).
for an illustration of the card retention door).
Cover).