Replacing The Battery Latch Assembly - Dell Vostro 1510 Service Manual

1 battery release button 2 alignment bracket screw (1)
3 battery latch assembly 4 spring
Replacing the Battery Latch Assembly
CAUTION: Before you begin the following procedure, follow the safety instructions that shipped with your computer.
NOTICE: Ensure the battery latch assembly is properly oriented. The indent for the screw should face up when installing the assembly.
This procedure assumes that you have completed the removal procedure
1. Ensure that the battery latch spring is properly mounted on the guide post of the battery latch assembly.
2. Align the battery release button with the hole in the battery latch assembly, then press the button into place.
3. Replace the M2 x 3-mm screw that holds the battery release button in the battery latch assembly.
4. Align the guide post on the battery latch assembly with the slot on the base of the computer, then lower the latch assembly into place.
NOTICE: The battery release button is keyed to ensure proper alignment. If you feel resistance, check the alignment of the release button.
5. Replace the system board (see
6. Connect the cable that secures the internal card with Bluetooth wireless technology to the system board (see
7. Replace the optical drive (see
8. Replace the palm rest (see
9. Replace the display assembly (see
10. Replace the keyboard (see
11. Replace the hinge cover (see
12. Replace the fan (see Replacing the
13. Replace the hard drive (see
14. Replace the WLAN card (see
Back to Contents Page
Replacing the System Board Assembly).
Replacing the Optical Drive).
Replacing the Palm Rest).
Replacing the Display Assembly).
Replacing the Keyboard).
Replacing the Hinge Cover).
Fan).
Replacing the Hard Drive).
Replacing a WLAN Card).
Removing the Battery Latch Assembly.
Replacing the Card).