Replacing The Display Assembly; Display Bezel - Dell Vostro 1510 Service Manual

11. Lift the display assembly out of the computer.
1 display cable 2 antenna cables
3 display assembly

Replacing the Display Assembly

CAUTION: Before you begin the following procedure, follow the safety instructions that shipped with your computer.
This procedure assumes that you have completed the removal procedure
1. Align the display hinges with the holes in the base of the computer, then lower the display into place.
NOTICE: Ensure that the display cable and antenna cables are properly routed and secured beneath the plastic tabs on the palm rest.
2. In sequential order, replace the four M2.5 x 5-mm screws into the base of the display assembly.
3. Route the display cable and antenna cables beneath the plastic tabs on the palm rest.
4. Slide the antenna cables through the hole in the palm rest and the base of the computer.
5. Connect the display cable to the display cable connector on the system board.
6. In sequential order, replace the four M2.5 x 5-mm screws in the base of the display assembly.
7. Replace the keyboard (see
8. Replace the hinge cover (see
9. Close the display and turn the computer upside down.
10. Replace the M2.5 x 8-mm screw that attaches the display assembly to one corner of the computer.
11. Replace the WLAN card (see
12. Replace the hard drive cover. See
Display Bezel
Replacing the Keyboard).
Replacing the Hinge Cover).
Replacing a WLAN Card).
Removing the Hard Drive for an illustration of the hard drive cover.
Removing the Display Assembly.