Kenmore 758.154140 Operator's Manual page 8

Whole house humidifier 14 gallon output with innovative twin fan technology
Table of Contents

Advertisement

Available languages

Available languages

SP6593
Sears
Kenmore
7/21/@5
2:16
PH
_ge
8
Operating
Humidifier
Controls
(cont'd.)
Once the right bottle empties, the
humidifier will begin to use the water from
the Ieft bottle until it is depleted. At this
time the filI indicator beside it will
illuminate. There will still be a slight delay
in the unit shutting off while it depletes
the water in the bottom of the cabinet. At
this time or anytime during normal
operation you may filI the water bottles to
continue operation.
NOTE: A small amount of water remains
in the cabinet after both filI indicators turn
on and the unit shuts off.
Left
Bottle
Gauc
Manuat Oryout:
At the end of the humidification
season or
if you do not plan to run the humidifier for
one week or more, you can override the
automatic shutoff function to completely
dry the hum[differ cabinet out.
To do this, simply slide the float retainer
located at the back of the humidifier
cabinet to the top position of the slot it is
located in. This will hold the float in an
upward position and the fans wilI run until
you turn the power off.
NOTE: Be sure to position float retainer
to the normal operating mode (lowest
position in slot) for hum[differ operation.
The following diagram is of the slot the
float retainer is located in at the back of
the cabinet.
Bottle
ght Gauge
Back of Cabinet
Bottle
Bottle
Fill Indicator
Fill Indicator
Top Position
ie for Manua_
Dryout
Bottom
Position
is for Normam
Operation
Mode
\
Hoat
Retainer
S_ot
Using Your Humidifier
Step 1 :
Be sure humidifier is futl of water and
plugged in.
Step 2:
Set Speed Control " _
" to lowest
speed ",,".
Step 3:
Set Humidity Control " _
" to medium
position.
NOTE: Hum[differ should operate with
humidity control on the recommended
medium setting. If it does not, the
humidity is at a relatively high level
To test the unit under this condition, turn
Humidity Control all the way to clockwise
and unit should begin to operate. After
the unit has been tested, set Humidity
Control to medium or desired level.
Step 4:
if humidifier stops running and BOTH Fill
indicators are not on, the humidity level is
at the normal requirements for that
setting or it is adjusting to the home
conditions. The chart on page 9 shows
recommended
indoor humidity levels.
The following figure shows approximate
relative humidity percentages which
correspond to the various settings of the
Humidity Control.
q>

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents