Kenmore 758.144118 Owner's Manual page 16

Troubleshooting
Probable Cause Remedy
Trouble
Red power light and digital " No Powera ,, Check 120 volt power sourcea
display not illuminated. ,, Power button has not been ,, Press power button once to
depressed, turn on.
Fan not operating (Red power ,, ROOM humidity level is 1% ,, Raise SET humidity level if
light and digital display is or more above SET humidity desired.
illuminated), level.
Fan running continuously. ,, SET humidity level is 65%.
e ROOM humidity level is 3%
or more below SET humidity
level.
,, A SET humidity percentage
of 65% operates fan
continuously. Adjust SET
level between 30% - 60%.
o Continue to run until desired
humidity level is achieved.
This may take up to 48 hours
initially.
o This unit is designed to satis-
fy an area up to 2,500 sq. ft.
e Humidifier under size for
requirements.
Poor evaporation of water, e CHECK FILTER message o Change to a fresh new
flashing, filter.
Bottle empties completely, e This is normal for initial filling, o Refill bottle for maximum run
time.
Bottle continues to empty e Air is entering water bottle, o Ensure fill cap is tightened
after initial filling, securely.
,, Ensure gasket on fill cap is
in place.
o Check for leak in water bottle.
Bottle not emptying. ,, Spring Valve Assembly
damaged or missing post
in bottom of base.
e Base full of water.
,, Check orientation of bottle.
Reposition so that spring
valve on bottom of bottle is
depressed by post in bottom
of base.
e The base will hold the con-
tents of water bottle (2.0 gal-
lons). Continue to run
humidifier to deplete water
from base.
CAUTION: Use only 42-14900 EPA Registered Bacteriostat availabme from Sears
Retail store,
Use of other water treatment products may damage the filter component.
Under no circumstances should you use water treatment products designed for
Roto beretor Ultrasonic humidifiers,
16