Safety Instructions - Cisco Aironet 2600 Getting Started Manual

Management Frame Protection (MFP) (not available on autonomous or standalone models)
–
BandSelect (not available on autonomous or standalone models)
–
Throughput, forwarding, and filtering performance scaled to meet 3 spatial stream, 450 Mbps
–
data-rates
• 32 MB flash size
• 802.11af/at
CDP (Cisco Discovery Protocol)
–
• 2.4 GHz and 5 GHz 802.11n radios with the following features:
3TX x 4RX
–
3-spatial streams, 450 Mbps PHY rate
–
Spectrum intelligence
–
DPD (Digital Pre-Distortion) technology
–
Cisco Vector Beamforming—Implicit Co-phase beamforming for .11ag clients and 1
–
spatial-stream and 2 spatial-stream clients
Radio hardware is capable of explicit compressed beamforming (ECBF) per 802.11n standard
–
3

Safety Instructions

Translated versions of the following safety warnings are provided in the translated safety warnings
document that is shipped with your access point. The translated warnings are also in the Translated
Safety Warnings for Cisco Aironet Access Points, which is available on Cisco.com.
Warning IMPORTANT SAFETY INSTRUCTIONS
This warning symbol means danger. You are in a situation that could cause bodily injury.
Before you work on any equipment, be aware of the hazards involved with electrical
circuitry and be familiar with standard practices for preventing accidents. Use the
statement number provided at the end of each warning to locate its translation in the
translated safety warnings that accompanied this device. Statement 1071
SAVE THESE INSTRUCTIONS
Warning Read the installation instructions before you connect the system to its power source.
Statement 1004
3