Table of Contents
Advertisement
After selecting the choice, a map
screen will be displayed.
Rotate the Interface Dial knob
to select the map scale (available
scales are 1/20, 1/8, and 1/4 mile
scales). Use the Interface Dial to
move the crosshairs (red circle) to
the desired start point and push in on
the Interface Dial to "set" the start
point. Then move the Interface Dial
in a straight or diagonal direction to
encompass the area to be avoided.
NOTE:
The maximum size of the "Avoid area"
is 800 meters in length or width.
The selected area will be displayed as a
shaded box with a yellow border. Push
in on the Interface Dial to set the end
point of the avoided area. To "redraw"
the area, select CANCEL and repeat
the area selection process.
2010 TL
System Setup
Say or select OK to return to the Edit
avoid area screen.
If your selected area contains a freeway,
the system will prompt you with a pop-
up box saying "Do you want to avoid
freeways?" Answering "No" allows
you to enter a route through an avoided
area on a freeway and skip the "Avoid
area caution box" (see Pop-ups and
Disclaimers on page
71
).
When you return to the Edit avoid
area screen, the "Vicinity" fi eld is
automatically fi lled in by the system.
Re-edit the area "Name" if desired.
Select OK on the Edit avoid area screen
to fi nish editing. Your new avoided area
will now appear on the "Avoid area" list
and be viewable on the map screen.
NOTE:
You can select areas to avoid, however
you cannot select roads or areas that
you want the system to use for routing.
Navigation System 107
Advertisement
Table of Contents
