Partial Scan Mode - Sony XC-HR90 Technical Manual

Ccd black-and-white video camera module
Hide thumbs Also See for XC-HR90:
Table of Contents

Advertisement

Partial Scan Mode

You can increase the frame rate by setting the upper
high-speed transfer (FPS) and the lower high-speed
transfer (RPS) via the RS-232C interface. When the
RS-232C ON/OFF switch is set to OFF, you can set
Notes
• In trigger shutter mode, video out signals are output
about 1 H later than the external VD.
• In partial scan mode, image output and the WEN
rising edge are always synchronized, but the WEN
width becomes undefined.
Dip switch setting
Switch 5
Switch 10
Operating mode
1/2 V partial scan
1/4 V partial scan
the 1/2 partial scan mode or 1/4 partial scan mode by a
combination of switch 5 and switch 10 located on the
rear panel.
The image is centered as shown below.
X lines
Mode Settings
960 lines
20

Advertisement

Table of Contents
loading

Table of Contents