Fujitsu SPARC Enterprise M3000 Xscf Reference Manual page 287

The setssh(8) command can register one user public key at a time.
■
In time of setssh(8) command execution, finish the input of user public key by
■
pressing Enter and then pressing "Ctrl" and "D" (EOF).
In case the XSCF unit is duplicated configuration, the setting automatically
■
reflected to the standby XSCF. When there is a defect on the standby XSCF, it
leads to an error and the setting will be reflected to the active XSCF only.
When you use the setssh(8) command to disable the SSH service (setssh -c
■
disable), the SSH service is disabled immediately. At this time any open SSH
sessions are terminated.
For all other settings using the setssh(8) command, you must reboot the XSCF
using rebootxscf(8) command for the changes to take effect.
Using the showssh(8) command, you can check the current settings of the SSH
■
service.
EXAMPLES
EXAMPLE 1
XSCF>
Continue? [y|n] :
Please reset the XSCF by rebootxscf to apply the ssh settings.
EXAMPLE 2
XSCF>
Continue? [y|n] :y
Please reset the XSCF by rebootxscf to apply the ssh settings.
EXAMPLE 3
XSCF>
EXAMPLE 4
XSCF>
EXAMPLE 5
XSCF>
Host key create. Continue? [y|n] :
Please reset the XSCF by rebootxscf to apply the ssh settings.
Starts the SSH service.
setssh -c enable
y
Starts the SSH service. Automatically replies with "y" to the prompt.
setssh -y -c enable
Starts the SSH service. Automatically replies with "y" without displaying the
prompt.
setssh -q -y -c enable
Stops the SSH service.
setssh -c disable
Generates a host public key for SSH2.
setssh -c genhostkey
y
System Administration
setssh(8)
265