Fujitsu SPARC Enterprise M3000 Xscf Reference Manual page 166

setaltitude(8)
EXAMPLES
EXIT STATUS
SEE ALSO
144 SPARC Enterprise Mx000 Servers XSCF Reference Manual • Last Revised September 2008
To apply the specified configuration, execute the rebootxscf(8) command and
■
reset XSCF.
The command does not accept negative numbers. If the system is below sea-level
■
use altitude=0.
When you specified either of the altitude of the system or whether or not the air
■
filter installed, the current settings are listed. The setting of the air filter is
displayed only when it is set to installed.
When the showaltitude(8) command is executed, the current settings are
■
displayed.
Sets the altitude of the system to 1000 m.
EXAMPLE 1
setaltitude -s altitude=1000
XSCF>
1000m
Sets the altitude of the system to 200 m. The specified value is rounded up to
EXAMPLE 2
the nearest hundred meters.
setaltitude -s altitude=157
XSCF>
200m
Sets the altitude of the system to 1000 m, on the M4000/M5000 servers with
EXAMPLE 3
the air filter installed.
setaltitude -s altitude=1000
XSCF>
1000m
Filter is installed.
Sets the air filter uninstalled, on the M4000/M5000 servers.
EXAMPLE 4
setaltitude -s filter=uninstalled
XSCF>
1000m
The following exit values are returned:
Successful completion.
0
An error occurred.
>0
showaltitude(8)