Fujitsu ScanSnap fi-5110EOXM Operator's Manual page 89

Color image scanner for macintosh
Hide thumbs Also See for ScanSnap fi-5110EOXM:
Table of Contents

Advertisement

Symptom
Scanning does not
start.
Vertical lines appear in
the scanned image.
The scanned image
shifts or is distorted.
The scanned image is
too light or too dark.
Check This Item
Is the USB cable connected
correctly?
Does the
LED light
blink?
Is ScanSnap Manager
started?
(If ScanSnap Manager is
started successfully, the
"ScanSnap Manager" icon
and the triangle in
the Dock menu appears.)
Is ScanSnap Manager
running normally?
(If ScanSnap Manager is
not running normally, the
"ScanSnap Manager" icon
in the Dock menu becomes
.)
Depending on the
computer, if it goes into the
sleep mode before turning
off the power, the scanner
may not be recognized
shortly after the power is
turned on back.
Is the "Scan and Save Set-
tings" window still
displayed?
Is the inside of the ADF
dirty?
Is the document loaded
correctly?
In B&W scanning, is the
setting "Brightness" (Black
and White scanning only)
set to extremely Light or
Dark?
ScanSnap fi-5110EOXM Operator's Guide
5.2 Troubleshooting Checklist
Remedy
Connect the USB cable correctly. (When a
hub is used, check the hub's power supply.)
Disconnect and then re-connect the AC cable
and AC adapter.
If the "ScanSnap Manager" icon is not
displayed, from the Finder, select the installed
destination of ScanSnap (generally, "Applica-
tions" - "ScanSnap") - "ScanSnap Manager" to
start up "ScanSnap Manager".
Perform the following:
1. Disconnect and re-connect the AC cable
and AC adapter. If this does not change
the state, perform step 2.
2. If a USB hub is being used, directly
connect ScanSnap to your computer.
If this does not change the state, perform
step 3.
3. Restart your computer.
If none of the above operations resolves the
problem, uninstall and re-install ScanSnap
Manager.
Close the "Scan and Save Settings" window,
and restart scanning.
Clean the inside of the ADF following the
instructions in "6 Daily Care" (page 77).
Load the document correctly.
Adjust "Brightness" at [Scanning] - [Option...]
in the "Scan and Save Settings" screen.
5
73

Advertisement

Table of Contents
loading

Table of Contents