Cropping (SNC-EP550/EP580/ER550/
ER580/ER585/ER585H/ZP550/ZR550)
You can crop a portion of the image and display the
cropped image on the computer. Cropping reduces the
transmitting data size and thus the network load, and a
higher frame rate is achieved.
Select On to crop the image, or Off.
Notes
• This function is not available if Letterbox is set to On.
• If this function is enabled, the motion detection
function will not be available.
• When cropping Video out images, the aspect ratio of
the output images and the actual cropped images will
differ. (SNC-ZP550/ZR550)
To crop an image
1
Set Cropping to On and click the Area setting
button.
The area setting window appears.
2
Click on the still image to specify the trimming
portion.
A red frame that appears when you clicked
indicates the trimming portion.
The trimming portion is determined as shown below:
Point rotated by 180° around the
axis of the center of still image
Still image
Red trimming
Center of still
Clicked point
frame
image
To change the trimming portion, click on another
point on the image.
3
Click OK at the bottom of the window.
The cropped image is displayed on the main viewer.
4
To close the image, click
in the upper-right
corner.
Image 1 and Image 2
Up to two image codec modes can be set. Configure the
following setting for each image mode.
Page 49