Fujitsu fi-4120C2 Operator's Manual page 87

Symptom 3
The scanning does not start.
Is the document loaded correctly
on the ADF paper chute?
YES
Is the ADF closed completely?
YES
Is the interface cable connected
correctly?
YES
Is the connector of interface
cable broken?
NO
(when using scanner on SCSI
interface)
Is the SCSI ID set correctly?
YES
Does the scanning start after
running ON the scanner again?
NO
If you cannot solve the problem
after taking measures, check the
items in "5.3 Items to check before
contacting the dealer where you
bought the scanner" and contact
the dealer or an authorized
FUJITSU service provider.
*1) For details, refer to "Getting Started" 2.1 Installing the Scanner.
"Getting Started" 2.2 Connecting the scanner to your PC
*2) For details, refer to
5.2 Remedying Typical Troubles
NO
Load document correctly on
ADF paper chute.
NO
Close the ADF completely.
NO
Connect interface cable
correctly. (*2)
YES
Use a new interface cable
and correctly connect it.
Turn OFF the scanner and set
NO
the SCSI ID correctly, then
turn ON the scanner again.
(*2)
YES
The scanner operation is
normal.
fi-4120C2 Image Scanner Operator's Guide
5
.
71