Intel Amt Web Gui - Dell Precision M4500 Administrator's Manual

Intel AMT Web GUI

The Intel AMT WebUI is a Web browser-based interface for limited remote computer management. The WebUI is often used
as a test to determine if Intel AMT setup and configuration was performed properly on a computer. A successful remote
connection between a remote computer and the host computer running the WebUI indicates proper Intel AMT setup and
configuration on the remote computer.
The Intel AMT WebUI is accessible from any Web browser, such as the Internet Explorer or Netscape.
Limited remote computer management includes:
Hardware inventory
Event logging
Remote computer reset
Changing of network settings
Addition of new users
NOTE: Information on using the WebUI interface is available on the
Perform the following steps to connect to the Intel AMT WebUI on a computer that has been configured and set up.
1. Turn on an Intel AMT capable computer that has completed Intel AMT setup and configuration.
2. Launch a Web browser from a separate computer, such as a management computer on the same subnet as the Intel
AMT computer.
3. Connect to the IP address specified in the MEBx and port of the Intel AMT capable computer. (example:
http://ip_address:16992 or http://192.168.2.1:16992)
By default, the port is 16992.
NOTE:
configured and set up in the Enterprise mode.
If DHCP is used, then use the fully qualified domain name (FQDN) for the ME. The FQDN is the combination of
the host name and domain. (example: http://host_name:16992 or http://system1:16992)
4. The management computer makes a TCP connection to the Intel AMT capable computer and accesses the top level
Intel AMT-embedded Web page within the Management Engine of the Intel AMT capable computer.
5. Type the username and password. The default username is admin and the password is what was set during Intel AMT
setup in the MEBx.
6. Review the computer information and make any necessary changes.
NOTE: You can change the MEBx password for the remote computer in the WebUI. Changing the password in the
WebUI or a remote console results in two passwords. The new password, known as the remote MEBx password,
only works remotely with the WebUI or remote console. The local MEBx password used to locally access the
MEBx is not changed. You have to remember both the local and remote MEBx passwords to access the computer
MEBx locally and remotely. When the MEBx password is initially set in Intel AMT setup, the password serves as
both the local and remote password. If the remote password is changed, then the passwords are out of sync.
7. Select Exit.
Use port 16993 and https:// to connect to the Intel AMT WebUI on a computer that has been
Intel AMT website