Display Bezel; Installing The Display Assembly; Removing The Display Bezel - Dell Precision M20 Service Manual

Dell precision m20 service manual

Hide thumbs Also See for Precision M20:

Table of Contents

8. Lift the display assembly out of the computer base.

1. Align the display assembly over the screw holes in the base of the computer.

2. Replace the four M2.5 x 5-mm screws.

3. Route the two antenna cables under the routing clips.

NOTE:

Ensure that you route the antenna cables under the routing clips. Failure to do so could result in your keyboard not seating properly.

4. Replace the keyboard.

5. Replace the

center control

cover.

Display Bezel

CAUTION:

Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.

NOTICE:

To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such

as the back panel) on the computer.

1. Follow the instructions in

"Preparing to Work Inside the

2. Remove the

center control

cover.

3. Remove the keyboard.

4. Remove the

display

assembly.

5. Use a plastic scribe to pry the six display bumpers out of the screw holes located on the front of the bezel.

6. Remove the six M2.5 x 5-mm screws located on the front of the bezel.

Computer."

Table of Contents