Dell Precision M20 Service Manual page 11

Dell precision m20 service manual
Hide thumbs Also See for Precision M20:
Table of Contents

Advertisement

NOTICE:
Ensure that the cam lock is in the fully open position before seating the microprocessor module. Seating the microprocessor module properly in
the ZIF socket does not require force.
NOTICE:
A microprocessor module that is not properly seated can result in an intermittent connection or permanent damage to the microprocessor and
ZIF socket.
 
1. Align the pin-1 corner of the microprocessor module with the pin-1 corner of the ZIF socket, and insert the microprocessor module.
NOTE:
The pin-1 corner of the microprocessor module has a triangle that aligns with the triangle on the pin-1 corner of the ZIF socket.
NOTICE:
You must position the microprocessor module correctly in the ZIF socket to avoid permanent damage to the module and the socket.
When the microprocessor module is correctly seated, all four corners are aligned at the same height. If one or more corners of the module are higher
than the others, the module is not seated correctly.
 
2. Tighten the ZIF socket by turning the cam screw clockwise until you cannot turn the screw any further to secure the microprocessor module to the
system board.
 
3. Replace the other computer parts you removed earlier in this procedure.
 
4. Update the BIOS using a flash BIOS update program CD. For instructions on how to flash the BIOS, see
Back to Contents Page
 
"Flashing the
BIOS."

Advertisement

Table of Contents
loading

Table of Contents