Dell Inspiron X200 Service Manual page 9

1 M2 x 6-mm screws (2)
4. Turn the computer over, and remove the two M3 x 5-mm screws from the bottom of the computer.
1 M3 x 5-mm screws (2)
5. Turn the computer over, and open the display 180 degrees.
6. Disconnect the antenna connector.
NOTICE: Do not pull on the signal cable and inverter cable. Pull from the signal connector and inverter connector to disconnect the cables.
7. Disconnect the signal cable from the system board.
8. Remove the tape that secures the inverter connector, and then disconnect the inverter cable from the system board.