Download Print this page

Dell Inspiron Mini 1012 Service Manual: Replacing The Palm Rest Assembly

Service manual.
Hide thumbs

Advertisement

1
power button cable connector
3
screws (3) 
 
CAUTION:
Carefully separate the palm rest assembly from the computer base to avoid damage to the palm rest assembly.
 
10. Using a plastic scribe carefully pry out the palm rest assembly along the rear edge and then ease the palm rest assembly from the computer base.
1
palm rest assembly
 
11. Lift the palm rest assembly off the computer base.
 Replacing the Palm Rest Assembly
 
1. Follow the procedures in
Before You
 
2. Align the palm rest assembly on the computer base and gently snap the palm rest assembly into place.
 
3. Slide the touch pad cable into the connector on the system board and, press down on the locking tab to secure the touch pad cable.
 
4. Connect the power button cable to the connector on the system board.
 
5. Replace the three screws that secure the palm rest assembly to the computer base.
 
6. Replace the hard-drive assembly (see
 
7. Replace the keyboard (see
 
8. Turn the computer over and replace the four screws that secure the palm rest assembly to the computer base.
 
9. Replace the battery (see
Replacing the
 
2
touch pad cable
Begin.
Replacing the Hard-Drive
Replacing the
Keyboard).
Battery).
Assembly).

Advertisement

   Also See for Dell Inspiron Mini 1012

   Related Manuals for Dell Inspiron Mini 1012

Comments to this Manuals

Symbols: 0
Latest comments: