Playback/Editing
Note
•
The number of prints can be set from 0 to 999.
•
With a printer supporting PictBridge, the date print settings of the printer may take precedence
so check if this is the case.
•
It may not be possible to use the print settings with other equipment. In this case, cancel all the
settings, and reset the settings.
•
If the file is not based on the DCF standard, the print setting cannot be set.
•
[PRINT SET] cannot be set for motion pictures and pictures that were taken with the
[QUALITY] set to [
You can set protection for pictures you do not want to be deleted by mistake.
•
For details about the icon display during Burst Picture Group playback, refer to P139.
1
Select [PROTECT] on the [PLAYBACK] Mode menu. (P55)
2
Press 3/4 to select the item and then press [MENU/SET].
•
When [SINGLE IN BURST GROUP] or
[MULTI IN BURST GROUP] is selected, press 3/4/2/1 to
select burst picture group, and press [MENU/SET] to proceed to
3
step
.
•
When [CANCEL] is selected, see
"
settings
.
3
Select the picture, and then press
[MENU/SET].
When [MULTI] has been selected
•
Repeat these steps for each picture.
•
The settings are cancelled when
[MENU/SET] is pressed again.
•
Press [‚] to return to the menu screen.
∫ Cancelling all the [PROTECT] settings
1
Select [CANCEL] on the screen shown in step
2
Press 3 to select [YES] and then press [MENU/SET].
•
If you press [MENU/SET] while cancelling protection, the cancelling will stop halfway.
Note
•
The protect setting may not be effective on other equipment.
•
Even if you protect pictures on a card, they will be deleted if the card is formatted.
•
Even if you do not protect pictures on a card, they cannot be deleted when the card's
Write-Protect switch is set to [LOCK].
152
VQT3A48
].
P [PROTECT]
"
Cancelling all the [PROTECT]
[SINGLE]
Press 2/1 to select
the picture.
2
and then press [MENU/SET].
[MULTI]
Press 3/4/2/1 to
select the pictures.