Loading Media; Removing Media - Fujitsu Stylistic ST4000 Series User Manual

St4000 series tablet dock
Hide thumbs Also See for Stylistic ST4000 Series:
Table of Contents

Advertisement

Do not operate your media drive unless your
system is sitting on a relatively flat surface.
Using the drive when the system is not level
may damage the drive or prevent proper
operation.

LOADING MEDIA

(Refer to Figure 8 for the following steps)
To load a disc into your media player drive,
follow these steps:
1. Push and release the eject button on the
front of the drive to open the holder tray. The
tray will come out of the system a short
distance.
2. Gently pull the tray out until a media disc
can easily be placed in the tray.
There may be a protective sheet in the tray
from when it was shipped; please make sure
it is removed before operating the drive.
3. Place the media into the tray, label side up,
with the hole in the center of the disc. Snap
the disc onto the raised circle in the center
of the tray.
4. Gently push the holder tray back in until you
hear a click.

REMOVING MEDIA

(Refer to Figure 8 for the following steps)
1. Push and release the eject button on the
front of the media player drive. This will stop
the drive and the holder tray will come out
of the system a short distance.
2. Gently pull the tray out until the disc can
easily be removed from the tray.
3. Carefully remove the media disc from the
holder tray.
4. Gently push the holder tray back in until
youhear a click.
Ta bl e t D o c k U s e r 's G u i d e
Figure 8. Loading/Ejecting Media
9

Advertisement

Table of Contents
loading

Table of Contents

Save PDF