Restoring The Network Configuration - Dell 2335dn Multifunctional Laser Printer User Manual

7.
An IP address consists of 4 bytes.
8. Enter the numbers from the keypad and use Scroll (
press Select (
9. Enter other parameters, such as the Subnet Mask or Gateway , and then press Select (
).
10. After entering all parameters, press Cancel (
Dynamic Addressing (BOOTP/DHCP)
To assign the TCP/IP address automatically using a DHCP or BOOTP server on your network.
1. Press Scroll ( or
2. Press Scroll ( or
3. Press Scroll ( or
4. Press Scroll ( or
5. Press Scroll ( or
To assign the address from the BOOTP server, press Select (

Restoring the Network Configuration

You can return the network configuration to its default settings.
1. Press Scroll ( or
2. Press Scroll ( or
3. Press Scroll ( or
4. Press Scroll ( or
network configuration.
5. Power the printer off and back on or reset the network interface card.
).
) to highlight Setup and then press Select (
) to highlight Network Setup and then press Select (
) to highlight TCP/IP (IPv4) and then press Select (
) to highlight Set IP Address and then press Select (
) to highlight DHCP and then press Select (
) to highlight Setup and then press Select (
) to highlight Network Setup and then press Select (
) to highlight Clear Settings and then press Select (
) to highlight Yes and then press Select (
or ) to move between octets and then
) to return to the Standby mode.
).
).
) when BOOTP displays.
).
) to restore the
).
).
).
).
).