Changing The Default Settings - Dell 2335dn Multifunctional Laser Printer User Manual

2->1sided long edge: Scans both sides of the originals and prints each of them on a separate
sheet.
2->1sided short edge: Scans both sides of the originals and prints each one on a separate
sheet, but the information on the back side of the printout is rotate 180°.
2->2sided long edge: Scans both sides of the original and prints on both sides of the paper.
This function produces exactly the same print out from the originals.
5. If necessary, customize the copy settings including the number of copies, copy size, contrast, and
image quality by using the Copy menus. See
6. Press Start ( ) to begin copying.

Changing the Default Settings

The copy options, including contrast, image quality, copy size, and the number of copies, can be set to the
most frequently used modes. When you copy a document, the default settings are used unless they are
changed by using the Copy menus.
NOTE: While you set copy options, pressing Cancel (
to the default status.
To create your own default settings:
1. Press Scroll ( or
2. Press Scroll ( or
3. Press Scroll ( or
4. When the option you want to set appears, press Select (
5. Change the setting using the Scroll (
6. Press Select ( ) to save the selection.
7. Repeat steps 3 through 6, as needed.
8. Press Cancel ( ) to return to the Standby mode.
"Setting Copy
) to highlight Copy and then press Select (
) to highlight Copy Defaults and then press Select (
) to scroll through the setup options.
or ) or enter the value using the number keypad.
Options".
) cancels the changed settings and returns
).
).
) to access the option.