Dell 1815dn Multifunction Mono Laser Printer User Manual page 140

Add Paper &
Press Start
Invalid Cartridge
Connection Error
COMM. Error
Retry
Data Read Fail
Check USB key
Data Write Fail
Check USB key
Document Jam
Check Feeder
Door Open
Front Door
Duplex jam 0
Check Inside
Duplex jam 1
Check Inside
Enter Again
File Format
Not Supported
Fuser Door Open
Group Not
Available
Hsync Error
JAM 2 OPEN REAR
& FRONT DOOR
Job cancelled
by user
Job limit (15)
reached
Junk Fax
Job Cancelled
Line Busy
Try Later
Line Error
Retry
Low Heat Error
Cycle Power Once
Mail Excceds
Server Support
Memory Full
Cancel or Start
Memory Full
Divide the Job
Network Error
No Answer
Try Later
The bypass tray is empty in the manual feeder mode.
The toner cartridge you have installed is not for your
printer.
Connection with the SMTP server failed.
The printer has a communication problem.
Time expired while reading data.
Storing to the USB memory key failed.
The loaded document has jammed in the ADF.
The front cover is not securely latched.
Paper has jammed during duplex printing.
Paper has jammed during duplex printing.
You entered an unavailable item.
The selected file format is not suppoted .
The fuser door is not securely latched.
You have tried to select a group location number where
only a single location number can be used, such as when
adding locations for a broadcasting operation.
A problem has occurred in the Laser Scanning Unit (LSU). Unplug the power cord and plug it back in. If the problem
Paper has jammed in the paper exit area.
Cancel ( ) is pressed during transmission.
The number of jobs stored in the printer is 15 and you
are trying to add 16th job.
The received fax number is the number stored in memory
as junk fax number.
The receiving party did not answer or the line is already
engaged.
Your printer cannot connect with a remote printer or has
lost contact because of a problem with the phone line.
There is a problem in the fuser unit.
The mail size is larger than the supported size by SMTP
server.
The memory is full.
The memory is full.
There is a problem with the network.
The remote fax machine has not answered after several
redial attempts.
Delete the number after the delayed fax job is sent.
Load a sheet of print material and press Start (
need to press the button each page to be printed.
Install a Dell-genuine toner cartridge, designed for your
printer.
Check the server settings and the network cable.
Ask the sender to try again.
Try again.
Check the available USB memory space.
Clear the document jam. See "Clearing Jams in the
Close the cover until it locks into place.
Clear the jam. See "Duplex Jam 0".
Clear the jam. See "Duplex Jam 1".
Enter the correct item again.
Use the correct file format.
Open the rear cover and close the fuser door until it locks
into place. For the location of the fuser door, see
Exit Jam".
Use a speed dial number or dial the number manually
using the number keypad.
persists, call for service.
Clear the jam. See "Paper Exit Jam".
Try again after a few minutes.
Delete jobs in the printer or try later after completing
some jobs.
Change the Junk Fax Setup option.
Try again after a few minutes.
Try again. If the problem persists, wait for an hour or try a
different phone line if possible and then try to connect
again.
Or, turn the ECM mode on. See "ECM
Unplug the power cord and plug it back in. If the problem
persists, call for service.
Divide your mail or reduce the resolution.
Delete unnecessary documents, retransmit after more
memory becomes available.
Split the transmission into more than one operation.
Contact your network administrator.
Try again. Verify the number to make sure a fax can be
received.
). You
ADF".
"Paper
Mode".