Wsw29; Wsw30 - Brother DCP 8040 - B/W Laser - All-in-One Service Manual

APPENDIX 3 FIRMWARE SWITCHS (WSW)
Selector
No.
1
|
8
Selector
No.
1
|
3
4
5
6
|
8
NOTE:
Selector 4 is applicable to the European version only.
l Selector 4:
Setting this selector to "1" activates the duty cycle control that suppresses the rush current.
The duty cycle is 10-ms ON and 20-ms OFF.
However, the duty cycle control may emit switching noise to the AC line. Depending upon the
codes and regulations in the country, this selector should be set to "0."
l Selector 5:
Setting this selector to "1" (OFF) deactivates all of the drum cleaning prompt settings enabled
by selectors 5 to 7 of WSW42.
WSW29 (Function setting 7)
Function
Not used.
WSW30 (Function setting 8)
Function
Not used.
Duty cycle control of pulsed current
for the heat-fixing unit
Drum cleaning prompt settings
Not used.
Duty cycle control of pulsed current for the heat-fixing unit
Drum cleaning prompt settings
Setting and Specifications
Setting and Specifications
0: OFF
0: ON
A-34
1: ON
1: OFF