Chapter 7 Maintenance Mode; Entry Into The Maintenance Mode - Brother DCP 8040 - B/W Laser - All-in-One Service Manual

CHAPTER 7
1.

ENTRY INTO THE MAINTENANCE MODE

To make the machine enter the maintenance mode, press the Menu button,
*, 2, 8, 6, and 4 keys in this order.
Within 2 seconds
The machine beeps for approx. one second and displays "
LCD, indicating that it is placed in the initial stage of the maintenance mode, a mode in which
the machine is ready to accept entry from the keys.
To select one of the maintenance-mode functions listed in Section 2, enter the corresponding
2-digit function code with the numerical keys on the control panel. (The details of each
maintenance-mode function are described in Section 3.)
NOTE:
Pressing the 9 key twice in the initial stage of the maintenance mode makes the machine
exit from the maintenance mode, restoring it to the standby state.
Pressing the Stop button after entering only one digit restores the machine to the initial
stage of the maintenance mode.
If an invalid function code is entered, the machine resumes the initial stage of the
maintenance mode.
MAINTENANCE MODE
MFC-8440/8840D/8840DN, DCP-8040/8045D/8045DN
7-1
SERVICE MANUAL
" on the