Brother DCP 8040 - B/W Laser - All-in-One Service Manual page 141

CHAPTER 4 DISASSEMBLY AND RE-ASSEMBLY
(23) Disconnect the connector for the eject sensor harness from the thermistor relay PCB
ASSY.
(24) Release the eject sensor harness from the three hooks.
(25) Remove the bind B M3x10 Taptite screw, and then remove the eject sensor PCB ASSY.
(26) Remove the bind B M3x10 Taptite screw, and then remove the thermistor relay PCB
ASSY.
Eject sensor harness
Thermistor relay PCB ASSY
(27) Remove the paper eject actuator and eject actuator spring.
Hooks
Taptite, bind B M3x10
Paper eject actuator
1
Hook
Hook
FU frame lower
Fig. 4-108
3
2
FU frame lower
Fig. 4-109
4-60
Taptite, bind B M3x10
Eject sensor PCB ASSY
Eject actuator spring