Parallel, Serial And Usb Device Problems; Pc Card Problems - Fujitsu LIFEBOOK LifeBook C6577 User Manual

Problem
Parallel, Serial, and USB Device Problems
You have installed a parallel
port device, a serial port
device or a USB device.
Your LifeBook does not
recognize the device, or the
device does not seem to
work properly.

PC Card Problems

A card inserted in the PC
Card slot does not work or
is locking up the system.
Possible Cause
The device is not
properly installed.
The device may have been
installed while an application
was running, so your LifeBook
is not aware of its installation.
Your software may not
have the correct software
driver active.
You may have the wrong
I/O address selected for
your device.
Your device and another
device are assigned the same
I/O address.
Parallel port is set to
output only.
The card is not
properly installed.
The card may have been
installed while an application
was running, so your LifeBook
is not aware of its installation.
Your software may not
have the correct software
driver active.
You may have the wrong
I/O address selected for your
PC Card device.
Your PC Card device and
another device are assigned the
same I/O address.
T r o u b l e s h o o t i n g
Possible Solutions
Remove and re-install the device. (See Device Ports
on page 51 for more information)
Close the application and restart your LifeBook.
See your software documentation and activate the
correct driver.
See your device documentation and software docu-
mentation to determine the required I/O address.
Change the settings in the BIOS setup utility. (See
BIOS Setup Utility on page 33 for more information)
Check all I/O addresses located within the BIOS
setup utility and any other installed hardware or
software to make sure there are no duplications.
Check parallel port setting in the BIOS and set to
bi-directional or ECP.
Remove and re-install the card. (See PC Cards on
page 47 for more information)
Close the application and restart your LifeBook.
See your software documentation and activate the
correct driver.
See your PC Card documentation to determine
the required I/O address. Change the settings in
the BIOS. (See BIOS Setup Utility on page 33 for
more information)
Check all I/O addresses located within the BIOS
setup utility and any other installed hardware or
software to make sure there are no duplications.
61