Control Settings - GE GWS04HAESS Owners And Installation Manual

About the control and settings.

Control Settings

The temperature range of the wine center is intended
for 40°F (4.4°C) to 60°F (15.6°C). The display shows
the average temperature of the appliance. It is
normal for the actual temperature to vary slightly
during operation.
Auto Temperature Setting
When the appliance is plugged in or the "+" pad
is pressed, the appliance runs on the "Auto Bev"
setting of 44°F (6.7°C) and the "Auto Bev" indicator
light in the upper left corner stays lit.
NOTE: Display will flash when the "+" pad is
pressed.
Normal Temperature Setting
The temperature of the wine center can be set
anywhere between 41°F (5°C) to 61°F (16.1°C) by the
"+" and "–" pads.
Press and hold the SET pad. You will hear a
series of 2 beeps.
After the second beep, press the "+" and "–"
pads to increase or decrease the desired
temperature in increments of one degree.
During this time the display will flash.
When the Wine Center is Plugged In
After plugging in the wine center and setting the
desired temperature, allow the wine center to
reach the set temperature before loading your
wine. The temperature may take up to 12 hours to
completely stabilize.
After loading the wine or beverages, you may
notice the actual temperature rise. This is normal.
The actual temperature will continue to change
as the wine and beverages are cooled to the set
temperature. The temperature may take up to 12
hours to completely stabilize.
Interior Light
You can turn the light ON or OFF by pushing the
light switch located on the right side of the control
panel housing. The light gives off heat. If the interior
light is left on, it will raise the inside temperature.
Auto Bev
Indicator Light
Press SET to confirm your choice. The display
will stop flashing. If no confirmation is made in
ten seconds, the unit will automatically accept
your change.
NOTE: When you change the temperature setting,
there may be a 5-minute delay until the compressor
starts to run.
Fahrenheit and Celsius
The temperature display can be changed between
Fahrenheit and Celsius by pressing and holding the
"+" pad for approximately 5 seconds.
Indicator Light
The indicator is lit when the compressor is
running to cool your unit. It will not be lit when the
compressor is idle.
Interior Light
To switch the interior light on/off, simply press the
pad.
A guide with wine serving
temperature suggestions
is located on the inside
right portion of the unit.
It gives recommended
temperatures for
different wines, as well as
instructions on adjusting
the temperature of the
wine center.
NOTE: The exterior of the
cabinet may get warm.
This is normal.
GEAppliances.com
5