Panasonic Toughbook FZ-G1 Operating Instructions Manual page 29

2 Perform the "First-time Operation" (è page 19).
NOTE
l The date and time, and the time zone may not be correct. Be sure to set them correctly.
3 Perform Windows Update.
4 <Only for model with TPM> Clear TPM.
A On the Start screen, flick from bottom side to inside of the screen and touch [All apps]
on the toolbar.
B Touch [Run] under "Windows System", input [tpm.msc] and touch [OK].
C Touch [Clear TPM ...] under "Actions" on the right of the "TPM Manager on Local Com-
puter" screen.
D Touch [Restart] of the "Manage the TPM security hardware" screen.
The computer will restart.
E W hen "TPM configuration change was requested to ..." is displayed, press F12 .
Windows will start.
F When "TPM is ready" appears, touch [Close].
1 Turn on the computer, and touch the top left corner of the screen sev-
eral times while [Panasonic] boot screen is displayed.
The Setup Utility starts up.
l If the [Panasonic] boot screen is not displayed, turn on the computer while touching the
top left corner of the screen.
l If the password is requested, enter the Supervisor Password.
2 Write down all of the contents of the Setup Utility and touch [Exit] and
double-touch [Load Default Values].
At the confirmation message, touch [Yes].
3 Touch [Exit] and double-touch [Save Values and Reboot].
At the confirmation message, touch [Yes].
Computer will restart.
4 Touch the top left corner of the screen several times while [Panasonic]
boot screen is displayed.
The Setup Utility starts up.
l If the password is requested, enter the Supervisor Password.
5 Select the [Exit] menu, then double-touch [Recovery Partition].
6 Touch [Reinstall Windows] and touch [Next].
The License Agreement screen appears.
7 Touch [YES].
The License Agreement screen appears.
8 Touch [Yes, I agree to the provisions above and wish to continue!] and
touch [Next].
9 Select the setting and touch [Next].
l [Reinstall Windows to the whole Hard Disk to factory default.]
Select this option when you want to install Windows to the factory default. After instal-
lation, you can create a new partition. For how to create a new partition, refer to "To
change the partition structure" (è page 21).
29