Rgb Input Mode; Convenient Functions; Display; Picture Mode - Fujitsu Plasmavision P42HTA51E Series User Manual

RGB INPUT MODE

CONVENIENT FUNCTIONS

DISPLAY

PICTURE MODE

PICTURE MEMORY

DUAL CHANNEL

OFF-TIMER

Note
• Functions may not be available with some models and some device options.
1
Press to select the input mode.
The input terminal of RGB mode is as follows.
• RGB1: mD-sub
* For selection of the input terminal, see
"SETTING THE INPUT TERMINALS" on
P. E-25.
Displaying on-screen information.
Press .
The channel or mode is indicated on the screen for 5 seconds.
Press .
This button can be used to switch the picture mode.
In the picture mode, you can switch between the set status and the fine mode.
* For the picture mode settings, see "Picture Mode (P. E-20)".
Press .
This button can be used to recall the settings of the picture memories 1 – 8. Each time this button is
pressed, the setting changes as follows.
Memory1 Memory2 Memory3 Memory4 Memory5 Memory6 Memory7 Memory8
* For the picture memory settings, see "Picture Memory (P. E-21)".
Press .
This function enables selection of the audio mode when there is a dual-channel broadcast. Each time this
button is pressed, the mode is switched as shown in the figure below.
Dual-I Dual-II Stereo Mono
Depending on the broadcast, this function may not be available.
Press .
This can be used to set the time before the power is turned off (Stand-by state). Each time this button is
pressed, the setting changes as follows.
Off 30 min. 60 min. 90 min. 120 min.
RGB1 mode
E-15