[Wss]; [Over Scan]; [Keystone]; [Auto Setup] - Panasonic PT-AE8000U Operating Instructions Manual

[WSS]

In the European broadcasting system, if the input
signal contains an identification signal, WSS
automatically switches the aspect ratio to the required
setting. (  page 61)
Switch settings
[ON] Switch automatically
[OFF] Do not switch automatically
Note
z Aspect ratio switches only in the case of these input
signals: PAL/625i (576i)/625p (576p)

[OVER SCAN]

If the 4 edges of an image are partly dropped, you can
use this function to adjust and project it properly.
Shrink image
z Setting range: 0 to +10
Note
z COMPUTER signal (exc. movie based signals) is not
supported.

[KEYSTONE]

If the projector is aligned non-perpendicularly to the
screen, or if the projection screen has an angled
surface, you can correct the keystone vertically.
Image
z Setting range: −32 to +32
Switch settings
Enlarge image
Operation
[POSITION] menu
Note
z You can correct the distortion ± 30 degrees from the
vertical plane. However, if there is overcorrection, the
image quality may deteriorate and become blurry. For a
better quality image, installing the projector with minimum
distortion is recommended.
z When adjustment with [KEYSTONE] carried out, the
vertical center of the screen and the lens need to be
realigned.
z The result of the keystone correction will affect the size of
the image.
z Keystone correction does not function on the menu
screen.
z Some distortion may occur due to lens shift adjustment.
z The result of the keystone correction may affect the
aspect ratio.
z When adjustment is performed with keystone correction,
the parallax adjustment result set in the [3D VIEWING
MONITOR] is discarded, and the parallax adjustment
function is disabled.

[AUTO SETUP]

COMPUTER IN (RGB) signals only (exc. movie based
signals)
When you select [AUTO SETUP] and then press the
<ENTER> button, [H-POSITION], [V-POSITION],
[DOT CLOCK], and [CLOCK PHASE] are adjusted
automatically in accordance with the input signal.
ENGLISH - 63