Electrical Specifications; Front Side Bus And Gtlref - Intel E5310 - Xeon 1.6 GHz 8M L2 Cache 1066MHz FSB LGA771 Active Quad-Core Processor Datasheet

Electrical Specifications

2
Electrical Specifications
2.1

Front Side Bus and GTLREF

Most Quad-Core Intel® Xeon® Processor 5300 Series FSB signals use Assisted
Gunning Transceiver Logic (AGTL+) signaling technology. This technology provides
improved noise margins and reduced ringing through low voltage swings and controlled
edge rates. AGTL+ buffers are open-drain and require pull-up resistors to provide the
high logic level and termination. AGTL+ output buffers differ from GTL+ buffers with
the addition of an active PMOS pull-up transistor to "assist" the pull-up resistors during
the first clock of a low-to-high voltage transition. Platforms implement a termination
voltage level for AGTL+ signals defined as V
power planes for each processor (and chipset), separate V
necessary. This configuration allows for improved noise tolerance as processor
frequency increases. Speed enhancements to data and address buses have made
signal integrity considerations and platform design methods even more critical than
with previous processor families. Design guidelines for the processor FSB are detailed
in the appropriate platform design guidelines (refer to
The AGTL+ inputs require reference voltages (GTLREF_DATA_MID, GTLREF_DATA_END,
GTLREF_ADD_MID and GTLREF_ADD_END) which are used by the receivers to
determine if a signal is a logical 0 or a logical 1. GTLREF_DATA_MID and
GTLREF_DATA_END are used for the 4X front side bus signaling group and
GTLREF_ADD_MID and GTLREF_ADD_END are used for the 2X and common clock front
side bus signaling groups. GTLREF_DATA_MID, GTLREF_DATA_END,
GTLREF_ADD_MID, and GTLREF_ADD_END must be generated on the baseboard (See
Table 2-18
GTLREF_ADD_END specifications). Refer to the applicable platform design guidelines
for details. Termination resistors (R
silicon and are terminated to V
on the processor to control reflections on the transmission line. Intel chipsets also
provide on-die termination, thus eliminating the need to terminate the bus on the
baseboard for most AGTL+ signals.
Some FSB signals do not include on-die termination (R
the baseboard. See
The AGTL+ bus depends on incident wave switching. Therefore, timing calculations for
AGTL+ signals are based on flight time as opposed to capacitive deratings. Analog
signal simulation of the FSB, including trace lengths, is highly recommended when
designing a system. Contact your Intel Field Representative to obtain the applicable
signal integrity models, which includes buffer and package models.
Quad-Core Intel® Xeon® Processor 5300 Series Datasheet
for GTLREF_DATA_MID, GTLREF_DATA_END, GTLREF_ADD_MID and
. The on-die termination resistors are always enabled
TT
Table 2-7 and
. Because platforms implement separate
TT
Section
) for AGTL+ signals are provided on the processor
TT
) and must be terminated on
TT
Table 2-8 for details regarding these signals.
and V supplies are
CC TT
1.3).
15