Pciexbar-Pci Express* Register Range Base Address (D0:F0) - Intel 925 - Pentium D 925 3.0GHz 800MHz 4MB-Cache Socket 775 CPU Datasheet

Host Bridge/DRAM Controller Registers (D0:F0)
4.1.14 PCIEXBAR—PCI Express* Register Range Base Address
(D0:F0)
PCI Device:
Address Offset:
Default Value:
Access:
Size:
This is the base address for the PCI Express configuration space. This window of addresses
contains the 4 KB of configuration space for each PCI Express device that can potentially be part
of the PCI Express hierarchy associated with the MCH. There is not actual physical memory
within this 256-MB window that can be addressed. Each PCI Express hierarchies require a PCI
Express BASE register. The MCH supports one PCI Express hierarchy.
The 256 MB reserved by this register does not alias to any PCI 2.3 compliant memory-mapped
space. For example, MCHBAR reserves a 16-KB space and reserves a 4-KB space both outside of
PCIEXBAR space. They cannot be overlaid on the space reserved by PCIEXBAR for devices 0.
On reset, this register is disabled and must be enabled by writing a 1 to PCIEXBAREN [Dev 0,
offset 54h, bit 31]
If the PCI Express Base Address [bits 31:28] were set to Fh, an overlap with the High BIOS area,
APIC ranges would result. Software must guarantee that these ranges do not overlap. The PCI
Express Base Address cannot be less than the maximum address written to the Top of physical
memory register (TOLUD). If a system is populated with more than 3.5 GB, either the PCI
Express Enhanced Access mechanism must be disabled or the value in TOLUD must be reduced
to report that only 3.5 GB are present in the system to allow a value of Eh for the PCI Express
Base Address (assuming that all PCI 2.3 compatible configuration space fits above 3.75 GB).
Bit
31:28
27:0
56
Access &
Default
R/W PCI Express* Base Address: This field corresponds to bits 31 to 28 of the
Eh base address for PCI Express enhanced configuration space.
BIOS will program this register resulting in a base address for a 256-MB block
of contiguous memory address space. Having control of those particular 4 bits
insures that this base address will be on a 256-MB boundary, above the lowest
256 MB and still within total addressable memory space, currently 4 GB.
The address used to access the PCI Express configuration space for a specific
device can be determined as follows:
PCI Express Base Address + Bus Number * 1 MB + Device Number * 32 KB +
Function Number * 4 KB
The address used to access the PCI Express configuration space for Device 1
in this component would be PCI Express Base Address + 0 * 1 MB + 1 * 32 KB
+ 0 * 4 KB = PCI Express Base Address + 32 KB. Remember that this
address is the beginning of the 4-KB space that contains both the PCI
compatible configuration space and the PCI Express extended configuration
space.
Reserved
0
48h
E0000000h
R/W
32 bits
Description
®
Intel 82925X/82925XE MCH Datasheet
R