Firmware; Misc - D-Link DSA-3100 - Airspot - Gateway User Manual

DSA-3100 Airspot Public/Private Gateway User Manual

5. Firmware

Available firmware upgrade of the DSA-3100 could be obtained from D-Link support web site.
Figure 4-69
Caution: Firmware upgrades might result in configuration data loss. Some other restrictions
might also apply. Please refer to the release notes of new firmware upgrades.
To replace the firmware with a new one, browse to find the firmware image file on your
computer and click Apply. The browser will upload the image onto the DSA-3100 and the
upgrade procedure goes on. When the system is upgrading its firmware, the Status LED
blinks until done. When finished, the web interface will also display a successful message.
The DSA-3100 must be restarted to have the new firmware take effect. If you made any
change to the configuration, remember to save settings before restarting the DSA-3100.
Caution: Please restart the DSA-3100 using the administration interface. Do not directly
power it off and up. Restarting the DSA-3100 this way after firmware upgrade might result in
corruption of the DSA-3100 firmware.

6. Misc.

Specify an IP address or network segment that connects to WAN Port to
be allowed for configuring DSA-3100. For instance, if 10.2.3.1 is
Remote Manage IP
specified, then the user will be allowed to connect to WAN Port and
configure DSA-3100 only from the specified address.
The DSA-3100 provides SNMP v2 Read-only (RO) management,
• Manager IP: A trap manager is a management station that receives and
SNMP
60
Firmware Upgrade From File
processes traps. When you configure a trap manager, assign IP
address to management station.